J968/1_199506 Diesel Injection Pump Testing-Part 1: Calibrating Nozzle and Holder Assemblies
06/27/1995
- Issuing Committee
- Content
This part of SAE J 968 specifies two types of calibrating nozzle and holder assemblies intended for the testing and setting of diesel injection pumps on test benches.
It applies to: a. a calibrating nozzle and holder assembly with a single hole orifice plate; and b. a calibrating nozzle and holder assembly with a delay pintle type nozzle.
The approximate range of the calibrating nozzle and holder assembly is up to: a. 300 mm₃/stroke with the single hole orifice plate; and b. 150 mm₃/stroke with the delay pintle type nozzle. Setting and maintenance requirements are specified in ISO 4008/3.
- Pages
- 14
- Citation
- SAE International Recommended Practice, Diesel Injection Pump Testing-Part 1: Calibrating Nozzle and Holder Assemblies, SAE Standard J968/1_199506, Reaffirmed June 1995, Revised May 1990, Issued May 1991, https://doi.org/10.4271/J968/1_199506.