J1061_200802 Surface Discontinuities on General Application Bolts, Screws, and Studs
02/22/2008
- Issuing Committee
- Content
- This SAE Recommended Practice defines, illustrates, and specifies allowable limits for various types of surface discontinuities that may occur during the manufacture and processing of bolts, screws, and studs in sizes through 24 mm or 1 in diameter inclusive with lengths to 150 mm or 6 in inclusive, having specified minimum tensile strengths of 900 MPa or 120 000 psi and greater, which are primarily intended for use in automotive assemblies. The basic recommended practice does not include inspection sampling requirements. It is intended that the purchaser shall specify, in the original inquiry and purchase order, the inspection sampling requirements which the producer must satisfy to demonstrate the acceptability of bolts and screws with respect to surface discontinuities.
- Pages
- 8
- Citation
- SAE International Recommended Practice, Surface Discontinuities on General Application Bolts, Screws, and Studs, SAE Standard J1061_200802, Revised February 2008, Issued July 1975, https://doi.org/10.4271/J1061_200802.